Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Yorba Linda?
Gate repair in Yorba Linda typically runs $150 to $650 for most residential driveway gates, with the average job landing around $275 to $375. The final price depends on your gate type, the brand of operator, and whether the problem is mechanical or electronic. Small fixes like hinge and latch adjustments sit at the low end. Control board replacements and operator failures push toward the higher end, and full operator replacement can go past $650.
We’re gate-only specialists, so we’ve spent years diagnosing the same failure patterns across LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems. That means fewer wasted hours on diagnosis, which keeps your bill down. Every estimate is free and written, and the written estimate sets the final price.
Call (855) 382-4716. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Most gate repairs in Yorba Linda land between $150 and $650.
- Electric gate repair (control boards, sensors, loop detectors, motors) starts around $200.
- Same-day service is often possible when you call before dispatch fills up.
- Free written estimates, no surprises.
- Brand-specific expertise across 9 manufacturers – we diagnose by brand logic, not guesswork.
Gate Repair Cost Breakdown (2026)
Here are the typical estimated ranges for common gate repair line items in the Yorba Linda area. These are estimates, not exact quotes; the written estimate after we look at your gate sets the final price.
| Repair Type | Typical Estimated Cost | Notes |
|---|---|---|
| Hinge repair or replacement | $150 – $350 | Includes welding or bolt-on hinges, alignment |
| Latch and alignment adjustment | $150 – $300 | Sagging gate, gate dragging, hard-to-close |
| Track and roller repair (slide gates) | $200 – $450 | V-track or cantilever alignment, roller replacement |
| Sensor and safety device repair | $200 – $450 | Photo eyes, safety edges, reversing sensors |
| Loop detector diagnosis and repair | $250 – $500 | Vehicle loops, exit loops, detector boards |
| Control board replacement | $300 – $600 | Board price varies heavily by brand |
| Motor or gear failure repair | $350 – $650 | Motor, gearbox, or drive assembly |
| Operator replacement (labor + setup) | $400 – $800 | Operator hardware billed separately |
| Full operator replacement (unit + labor) | $1,200 – $2,800+ | Depends on brand, slide vs. swing, gate weight |
What drives the price up: commercial-grade operators like FAAC, BFT, and DoorKing tend to cost more to repair than entry-level residential brands like Mighty Mule and Ghost Controls, mostly because the parts are heavier and the diagnostics take longer. Slide gates usually cost more than swing gates because track, roller, and loop systems add failure points. What brings it down: catching a problem early. A worn hinge that gets replaced for $200 today becomes a bent post and a misaligned gate in a year.
What Affects Gate Repair Pricing in Yorba Linda
- Gate type. Swing gates and slide gates fail in different ways. Swing gates are more likely to have hinge, latch, and alignment issues. Slide gates add tracks, rollers, and often a vehicle loop – more parts, more diagnostic time.
- Brand of operator. We work on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Each has its own board logic and failure signatures. Familiarity cuts down on guesswork and gets you a straighter answer on cost.
- Residential vs. light-commercial. Driveway gates on a single home usually cost less to fix than multi-unit or HOA gates, where heavier panels and more complex access control add time.
- Parts availability. Some brand parts are stocked locally; others have to be ordered. When a part is not in stock, we tell you up front what the lead time looks like and quote you accordingly.
- Mechanical vs. electronic. A mechanical problem (hinge, latch, track) is usually cheaper to fix than an electronic one (control board, sensor, loop detector). Electronic diagnosis takes longer.
- Whether it’s a repair or a replacement. If an operator is failing on a gate that’s already past its service life, repair can be throwing money at a problem that comes back. We’ll tell you honestly which side of that line your gate is on.
How to Save on Gate Repair
The biggest lever is early diagnosis. A gate that starts moving slowly, sounding different, or needing a second try to close is telling you something. Getting gate repair early usually costs far less than waiting for a hard failure.
- Fix before it fails. A sticking hinge today is a sheared post tomorrow. The first repair is almost always cheaper.
- Ask about parts vs. labor. On some jobs, the part is the biggest cost. On others, it’s diagnostic time. Knowing which your job falls into helps you make a fair decision.
- Get a written estimate. Ours is free. Free written estimates mean you can compare apples to apples if you get more than one quote.
- Don’t bypass safety sensors to save a few dollars. That’s a false economy and, on some systems, a genuine safety hazard. Sensor repair is a real fix; a bypass is not.
- Consider repair vs. replacement honestly. If your operator is 10+ years old and the control board is gone, a new operator can be cheaper over the next few years than repeated board replacements.
Call (855) 382-4716 for a free estimate. Reach us 24/7 by phone, with fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Gate Repair Cost
How much does it cost to repair a gate sensor in Yorba Linda?
Most sensor repairs run $200 to $450. That range covers photo-eye alignment, safety edge replacement, and reversing-sensor diagnostics. If the problem turns out to be a wiring fault rather than the sensor itself, the diagnosis time goes up slightly. Call (855) 382-4716 for an exact quote – estimates are free.
Is it cheaper to repair or replace a gate operator?
Repair is usually cheaper in the short term (typically $300 to $650 for a control board or motor repair), but replacement can win out if your operator is old, the board has failed before, or parts are hard to source. A new operator with installation typically runs $1,200 to $2,800+ depending on brand and gate type. The written estimate shows you both numbers so you can decide.
Can you come today?
Same-day service is often possible if you call before the dispatch window fills. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday. If a call comes in outside dispatch hours, we book it into the next opening. Call (855) 382-4716 to check availability.
Why does gate repair cost more in Yorba Linda than in some other areas?
Yorba Linda’s mix of larger residential lots, sloped driveways, and multi-unit properties means gates here are often heavier and more complex than the standard suburban swing gate. Heavier gates need sturdier hardware and take longer to work on. Commercial-grade operators like FAAC, BFT, and DoorKing add to that. For a straight answer on your specific gate, call (855) 382-4716 – the estimate is free.
What’s the cheapest way to fix a gate that won’t close?
Usually a latch and alignment adjustment, which typically runs $150 to $300. But “won’t close” has several possible causes, and sometimes it’s a sensor issue or a control board fault that costs more to fix. Getting the free estimate first is the cheapest move, because you’ll know which one you’re dealing with.
Why Gate Repair Pricing Varies So Much by Brand
We work on your brand, and that matters more than most homeowners expect. A LiftMaster control board swap and a Mighty Mule control board swap look similar on paper but involve entirely different parts, board logic, and troubleshooting steps. FAAC and BFT are built for heavier duty than Ghost Controls. DoorKing is common on HOA and multi-unit properties. We carry parts and knowledge for each of those lines, which means we can often give you a firm quote without a second trip.
Electric gate repair is one of our core services, not an afterthought. We handle operator boards, sensors, loop detectors, and motor failures – the kinds of jobs general handymen turn away. If your gate has stopped responding to the remote, opens halfway, or runs the motor without moving the gate, that’s the category of problem we specialize in.
For any gate problem that’s outside our scope – like a gate that needs structural welding or a fence repair – we’ll tell you and point you toward the right trade. Gate-only focus keeps our pricing honest because we’re not trying to make a repair quote cover a service we don’t actually do well.
What Happens When You Call
You call (855) 382-4716 and a live person takes the details: gate type, brand, what it’s doing and not doing. We answer 24/7, and dispatch runs 7am to 7pm, Sunday through Friday. From there, a technician comes out and diagnoses the gate, then gives you a written estimate before any work starts. The estimate is free. That’s true on every job, from a single hinge replacement to a full operator replacement.
If it’s a same-day emergency and we can fit you in, we will. If not, we’ll book the next available opening and give you a clear window. No call-back-the-next-business-day runaround.
Gate Repair, Electric Gate Repair, and New Gate Installation
Three service pillars, one company. We repair gates, we repair and replace electric gate systems, and we install new gates. That matters as your needs evolve – the same team that fixed your operator last year can install a whole new gate when the time comes, without you hunting for a different vendor. From residential driveways to multi-unit properties, we stay on the gate side of the work. Not fencing, not garage doors, not general handyman tasks. Gates, done properly.
If your gate is stuck, slow, noisy, or just not responding, the fastest way forward is a call. Gate repair in Yorba Linda starts with a free written estimate, and we know your brand.
Contact Us for a Free Estimate
Call (855) 382-4716 for a free estimate on gate repair, electric gate repair, or new gate installation in Yorba Linda. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Whether it’s a hinge that’s given up or a control board that’s stopped talking, we’ll tell you what it takes to fix it and what it costs before we start.
Related Pages
- gate repair Yorba Linda – our main repair page for the area.
- electric gate repair in Yorba Linda – for operator, sensor, and board issues.
- gate installation in Yorba Linda – when replacement is the right call.
- gate repair in Anaheim Hills – nearby service area.
- gate repair in Brea – nearby service area.
- gate repair in Placentia – nearby service area.
- gate repair in Fullerton – nearby service area.
- gate repair in Orange – nearby service area.
- LiftMaster gate repair – brand-specific service.
- FAAC gate repair – commercial and heavy-duty residential.
- DoorKing gate repair – HOA and multi-unit access systems.
- gate operator replacement guide – what to expect when a repair won’t hold.
Pricing reflects the Yorba Linda market as of 2026. Gate Repair Yorba Linda offers free estimates – call (855) 382-4716.
What Our Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Ramon Vargas"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
- Dale Parker"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Bethany Hoffman